Niekonwencjonalne sieciowanie mieszanin chlorosulfonowanego polietylenu i karboksylowanego kauczuku butadienowo-akrylonitrylowego

M. Kozioł; W. M. Rzymski

Published : 2022-09-01

Vol. 50 No. 7-8 (2005)

Unconventional crosslinking of the blends of chlorosulfonated polyethylene and carboxylated acrylonitrile-butadiene rubber

M. Kozioł W. M. Rzymski

Abstract

Interpolymeric crosslinking of chlorosulfonated polyethylene/carboxylated acrylonitrile-butadiene rubber blends (CSM/XNBR) (Table 2) with MgO in the presence of stearic acid at temp. 433 K (160 oC) for 30 min has been investigated. Effect of CSM containing various amounts of chlorine bonded (Table 1) on the properties of CSM/XNBR blends was studied as well. Extent of crosslinking was estimated on the basis of determinations of vulcametric torque (L) (Fig. 1), equilibrium swelling (Qv) in selected solvents and sol fraction content (fraction soluble in 2-butanone - S) (Tables 3 and 5). It was found that CSM did not undergo crosslinking in given conditions while in the blend with XNBR the interpolymeric reaction of both elastomers occurred. It was confirmed by bounded chlorine values, S and IR analysis (Fig. 2, Table 4). It was observed that degree of CSM bonding with the network depends on its type and content in the blend. Tensile strength (TSb), elongation at break (Eb) temperature dependence of dynamic loss tangent (tgd) and storage modulus (E') (Fig. 3) were determined using dynamic mechano-thermal analysis (DMTA) of cured CSM/XNBR blends. There were found ionic interpolymeric bonds of structure ~C-CO-O-+Mg+-O-SO2-C~ in cured CSM/XNBR blend [equations (1)-(3)] which gave the blend high mechanical strength and act as chemical compatibilizer.

Keywords

polietylen chlorosulfonowany ; karboksylowany kauczuk butadienowo-akrylonitrylowy ; mieszaniny elastomerów ; sieciowanie ; wiązania interpolimerowe ; właściwości mechaniczne chlorosulfonated polyethylene ; carboxylated acrylonitrile-butadiene rubber ; blends of elastomers ; crosslinking ; interpolymeric bonds ; mechanical properties

Similar Articles

K. J. Wilczyński, A. Nastaj, Modelling of starve fed single-screw extrusion of polyblends using non-conventional screws , Polimery: Vol. 61 No. 5 (2016)
T. Biela, M. Brzeziński, Supramolecular polylactides – methods of preparation and selected properties , Polimery: Vol. 61 No. 6 (2016)
J. Kijeński, M. Kijeńska, O. Osawaru, Plant fibers as alternatives to mineral fillers in thermoplastic composites – Ford's vision or Al Gore's? , Polimery: Vol. 61 No. 7-8 (2016)
T. Żuk, J. Pietraszak, M. Żenkiewicz, Modeling of electrostatic separation process for some polymer mixtures , Polimery: Vol. 61 No. 7-8 (2016)
K. Gradzińska, K. Łabęcka, A. Kowalewska, W. A. Stańczyk, Silsesquioxane nanocarriers in diagnostics and biomedicine , Polimery: Vol. 61 No. 4 (2016)
H. Mąka, T. Spychaj, R. Pilawka, P. Dziedzic, Influence of hybrid carbon nanofillers on the cure behavior and properties of epoxy material , Polimery: Vol. 61 No. 3 (2016)
R. Jędrzejewski, J. Piwowarczyk, K. Kwiatkowski, J. Baranowska, Polytetrafluoroethylene thin films obtained by the pulsed electron beam deposition method at different gas pressures , Polimery: Vol. 62 No. 10 (2017)
K. Moraczewski, Effect of surface layer modification method on thermal stability of electroless metallized polylactide , Polimery: Vol. 62 No. 10 (2017)
M. Sieradzka, R. Fryczkowski, B. Fryczkowska, D. Biniaś, C. Ślusarczyk, S. Rajba, J. Janicki, Influence of solvents on low-temperature reduction-exfoliation of graphene oxide , Polimery: Vol. 62 No. 11-12 (2017)
A. Gawłowski, J. Fabia, C. Ślusarczyk, A. Brzozowska-Stanuch, T. Graczyk, J. Janicki, Modification of polyamide 6 fibers with water-glass in the bath method , Polimery: Vol. 62 No. 11-12 (2017)

<< < 106 107 108 109 110 111 112 113 114 115 > >>

You may also start an advanced similarity search for this article.

Details

References

Statistics

Authors

Download files

PDF (Język Polski)

Zasady cytowania

Kozioł, M., & Rzymski, W. M. (2022). Unconventional crosslinking of the blends of chlorosulfonated polyethylene and carboxylated acrylonitrile-butadiene rubber. Polimery, 50(7-8), 587–592. Retrieved from https://ichp.vot.pl/index.php/p/article/view/1667

Citing articles via

Statistics

Total abstract views : 0

PDF Downloads : 0

M. Kozioł

Affiliation
Politechnika Łódzka, Instytut Polimerów, ul. Stefanowskiego 12/16, 90-924 Łódź

W. M. Rzymski rzymski@p.lodz.pl

Affiliation
Politechnika Łódzka, Instytut Polimerów, ul. Stefanowskiego 12/16, 90-924 Łódź